Does anyone have the overall length of an axial wrath center drive shaft,with it fully extended?...In inches.
I don't know if the stock shaft is a different length but the junfac shaft for the wraith is 142mm fully extended which is 5.590 inches.
7:30 PM [SHORTBUS25] yea i knwo how to google y do i need it for
7:30 PM [SHORTBUS25] i dont have no question for u
7:30 PM [SHORTBUS25] to goggle
7:31 PM [fishyblob] its google, not goggle
7:31 PM [fishyblob] you wear goggles, google is a number
7:31 PM [fishyblob] sheesh
7:31 PM [SHORTBUS25] same diff its looks the same
7:53 PM [SHORTBUS25] i think the pinion is a 78t
My Fleet
The number matters almost none on my rig or Lilpantheres.
Cut yours to fit with as much spline engagement as possible and still doesn't bind at full stuff. If found about a 1/8" clearance clears at full stuff.
Also curious why you want fully extended.
To me it sounds like you need to look at the max shafts in the Traxxas isle get something longer then you need and cut it your rig.
Last edited by Evan03; 09-26-2014 at 09:27 PM.
Hey Evan I'm pretty sure this was for his now mothballed trophy truck build.
My savage is a flux. A flux has an electronic speed controller. An electronic speed controller has a capacitor. Therefore my savage has a flux capacitor!
The only stupid question is the one left unasked