This is almost a must do if your tired of breaking those tabs that the tie rod connects to on the rear hub carrier!! As most of you know I am rather cheap and have already sprung for two sets of the aluminum integy HD rear hubs, however I don't want to spend anymore money. So with three screws on each side, six total screws a couple of drilled holes this is what I came up with!!

First thing I did was drill two holes on either side of the screw that holds the hub together. (on the new hubs there are two little dots that I drilled on)


Then to finish it off I put one on the bottom



I have ran these a lot and they are holding up great! Nothing broken yet!