here is the start of my cobbled together rc10gt. going to put it in the hands of my buddy elvin. god help us all.




so the engine is a O.S. clone i believe. most of the parts seem to match os parts and the crank case is a dead ringer for the cv series case.



check out the HSN! its a thumb screw type. kinda really old skool but i think this might be to elvin's advantage as its very easy to adjust and keep track of your adjustments (it has a clicker built in too)



thought this pipe would be right up his alley. its an old dual chamber pipe, i think its AE but i dont know for sure



the whole car is setup with the idea of being very easy to drive. gonna have a lot of push and hopefully enough rear bite.







so far the only obvious cobbling is the front knuckles. these were the older rc10 knuckles (though i believe the early model gt's used them too).




i still need gears/bearings for the tranny, one of the engine mount bits and a body of course.